How To Setup A Wireless Router

Setting up a Belkin Wireless Router.
Network diagram :

Step 1 : Find default gateway address

• Firstly, after setting up the network as the diagram above, once the power is on for all device press the reset button on the router for at least 10 seconds.
• Then in ur computer Go Start -> Run -> type CMD -> type ipconfig
• Find a address under default gateway (exp: 192.168.1.1)

Step 2 : Accessing Router Setings

• Open any browser( ie, mozilla, chrome...)
• Type the default gateway address you've obtained from Step 1 in the URL address space.
• If your are prompt to enter password as below LEAVE IT EMPTY and click submit.
• If you dont know the password, check this website for default router password here Router pass 1 or Router Pass 2 

Step 3: Set up network name 

• Click Wireless tab -> click Channel and SSID->  rename to the name u desire in the SSID > area.   ( i named mine belkin54g )  **this name is the broadcast name viewed by everyone who needs to connect this connection.
• Make sure the box Broadcast SSID is checked.
• Click Apply Changes.

Step 3: Set up security mode

• Click Security under Wireless tab
• Change the Security mode from Disabled to WPA-PSK(no-server)
• Enter a password at the pre-shared key(PSK) area. 
• Click Apply Changes.

**Note this password is used by everyone who needs to connect to the wireless router for internet access.

Step 4(optional): Configure admin password

• Under Utilities tab click System Settings
• Leave blank for Current Password
• Type in a new password and confirm it ** This password is set to access the router settings.
• Change the time zone to KL Singapore
• Under Remote Management -> check the box which says any IP can remotely manage this router
• Click Apply Changes below and exit.